How To Tap A Keg At Home

August 29, 2021 Post a Comment

Place the keg in the tub surround it with ice and then top up with cold water. Youll notice a few open slits at the top of the keg and a ball bearing in the middle.

Pin On Homebrew Beer

To ensure the tapping process goes by smoothly place the canister in the upright position.

How to tap a keg at home. When youre ready to imbibe open the carbon dioxide tank and adjust the pressure start with 12. It is important to get your keg cold before serving. Every man cave worth its salt should have some type of kegerator system and once that system is installed you will need to know how to tap the various types of kegs that will be central to this system.

How to Tap a Keg After transporting a keg to your home place the keg inside the fridge and allow it to settle for a minimum of one hour. This is a short video on how to tap a keg with a D-system coupler for your kegerator. Continue to fill the bucket to surround the sides of the keg with ice and cover the top.

Some people recommend adding ice to the water to lower the temperature. Keg Taps are your cheapest options when it comes to getting free-flowing beer in your home. Connect the CO2 line to the CO2 side of the coupler.

Kegs are your cheapest bet mainly because the beer generally doesnt stay at peak freshness too long. Then pull the coupler handle out while pushing the handle downwards until the handle is lowered and in the engaged position. Step 4 Once the coupler is in place pull the handle on the coupler away from the center of the keg and push down to the closed position.

Once a keg is installed into your kegerator you should give it at least two and preferably four hours to settle in before pouring. Insert the coupler into the keg bung and turn one quarter of a turn to secure. Line the notches up with the hole at the top of the keg.

The slits guide the taps notches and hold the tap in place. Whilst technically not a draught system these kegs are great for parties and one-off celebrations. Get a bucket large enough in diameter to hold your keg and fill the bottom with a layer of ice before placing the keg inside of it.

There are two tabs on the keg that will line up with the two grooves on the coupler. The coupler will fit into the grooves atop the keg. Bar none its time to tap into summer.

Place the toggle shut off valve into the closed position or upwards and set it aside. Also make sure you are pouring with the glass at an angle and this will help reduce foam from an improper pour. When inserting the coupler into the top of the keg line up the grooves and twist clockwise to lock the coupler in place.

Beer should enter the vinyl line at. The ball bearing serves as a stopper forced up from the pressure inside the keg. First rotate the coupler approximately 180 into the keg creating a firm seal.

Chill your keg for 4-5 hours before tapping to avoid warm and foamy beer. Without a tapped keg offering cold brew at the push of a button or the pull of a handle a man cave is well just another room in the house. Go grab the hose clamp and place it over the opposite end of the air hose before attaching it to the keg.

Youre about to screw the tap into place. Connect the beer line hose to the. You can then either connect a pressure regulator and beer lines or fit a picnic tap directly to the keg.

It also shows you how to set the pressure of your CO2 tank and how to p.

Pin On Jjennewein